Yamaha RX-V495 Mode D'emploi page 29

4
For a DVD/LD or TV/DBS source, the current input
mode is also shown.
* To change the input mode for the DVD/LD or TV/DBS
source, press INPUT MODE (or the button that you
have pressed to select the program source in step 3
on the remote control transmitter) once or more until
the desired input mode (AUTO or ANALOG) is shown
on the display. (See page 30 for details on switching
the input mode.)
Front panel
or
5
Select the main speakers to be used.
Front panel
* If you use two main speaker systems, press both A and B.
6
Play the source. (See page 32 for detailed information
on tuning.)
7
Remote control
8
Input mode
* These controls are only effective for the sound from the
When you have finished using this unit
Press STANDBY/ON on the front panel again or POWER on
the remote control transmitter to set this unit to the standby
mode.
Adjust the volume to the desired output level.
Front panel
or
If desired, adjust BASS, TREBLE, BALANCE, etc.
and use the digital sound field processor (see
page 38).
BASS: Turn this control clockwise to increase (or
counterclockwise to decrease) the low-
frequency response.
TREBLE: Turn this control clockwise to increase (or
counterclockwise to decrease) the high-
frequency response.
BALANCE: Adjust the balance of the output volume
from the left and right speakers to
compensate for sound imbalance caused
by the speaker location or listening room
conditions.
Front panel
main speakers.
Remote control
29