EUROM Alutherm Wi-Fi 1000 Manuel De L'utilisateur page 33

13. Drill two holes at the marked positions and
place the wall plugs.
14. Place the device (Figure 12, pos. 2) back on
the wall brackets (Figure 12, pos. 1).
15. Screw and tighten the device brackets (Figure
13, pos. 4) with a large screw (Figure 13,
pos. 3) to the wall (Figure 10, pos. 3) using a
Phillips screwdriver (Figure 13, pos. 2).
Temperature sensor (Optional)
CAUTION
For accurate temperature measuring use the external temperature sensor.
1. Make sure the ON/OFF switch is in the OFF
position (Figure 14, pos. 3)
2. Connect the temperature sensor connector
(Figure 14, pos. 2) to the sensor plug (Figure
14, pos. 1).
3. Place the temperature sensor approximately
2 meters away from the device.
Installation
WARNING
Do not put the power plug into the wall socket before the device is correctly
mounted or stands in the right place.
Do not use an extension cable; this can cause overheating and fire. If using an
extension cable is unavoidable, make sure it is undamaged and earthed. Use
an extension cable with a minimum power of 2500 Watt. Always unwind the
extension cable completely to prevent overheating.
Figure 13
Figure 14
33