EUROM Alutherm Wi-Fi 1000 Manuel De L'utilisateur page 31

1. Place the device on a vertical and solid
surface. Use a spirit level when placing the
device (Figure 9, pos. 1).
2. Place the device with a minimum distance
(Figure 9) of:
•
150 cm from the ceiling;
•
30 cm from the side walls;
•
30 cm from the floor;
•
50 cm clearance on the front side.
3. Do not mount the device:
•
immediately below a socket outlet;
•
on a ceiling or roof.
4. Drill two holes at least 610 mm above the
floor for the brackets. The distance between
the holes is approximately
(Figure 10, pos. A)*:
•
Alutherm 1000: 255 mm;
•
Alutherm 1500: 400 mm;
•
Alutherm 2000: 563 mm;
•
Alutherm 2500: 655 mm.
5. Place wall plugs (Figure 10, pos. 2).
6. Screw and tighten a left and a right bracket
(Figure 10, pos. 3) to the wall with a large
screw (Figure 10, pos. 4) using a Phillips
screwdriver (Figure 10, pos. 1).
* CAUTION
Be aware that these are the holes for the wall bracket and not the slots in the
heater.
Figure 9
Figure 10
31