EUROM Alutherm Wi-Fi 1000 Manuel De L'utilisateur page 34

CAUTION
Make sure that the main voltage is the same as indicated on the identification
label of the device. All electrical connections must stay dry under all
circumstances.
1. Make sure the device is correctly assembled.
2. Make sure the ON/OFF switch is in the OFF
position (Figure 15, pos. 1).
3. Place the power plug (Figure 15, pos. 2) into
an earthed wall socket that is easily
accessible. Use an earthed wall socket with a
minimum power of 2500 Watt.
Remote control
1. Remove the cover (Figure 16, pos. 1).
2. Remove the batteries (if present).
3. Insert two batteries (AAA 1.5 V) (Figure 16,
pos. 2) as indicated in the battery
compartment. Make sure to insert the
batteries correctly.
4. Replace the cover.
Operation
WARNING
Before every use, make sure that:
•
•
•
•
•
34
you operate the device with dry hands;
the device is clean and dry;
the device is not damaged;
the device is not covered or blocked;
the device is securely installed.
Figure 15
Figure 16