Kd-49X75Xxh / 49X74Xxh / 43X75Xxh / 43X74Xxh - Sony SU-WL450 Mode D'emploi

2
Connect the necessary cable(s)
to the TV.
Make sure to connect the cables before
installing the TV on the wall. You will be
unable to connect the cables when the TV
is installed.
Refer to the Reference Guide supplied with
your TV.
Note
 Subcontract the cable routing in the wall to a licensed
contractor.
 Bundle the connecting cables to prevent stepping on
them before wall mounting.
3
Detach the Table-Top Stand
from the TV.
Note
 When installing the Wall-Mount Bracket, do not use
the screws removed from the Table-Top Stand.
 Be sure to store the removed screws and unused
parts in a safe place, keeping them away from
children.
KD-49X75xxH / 49X74xxH /
43X75xxH / 43X74xxH
1
Detach the Table-Top Stand
from the TV.
Soft cloth
Note
 Make sure to place TV on the place where you put a
soft cloth on to prevent damaging display's surface.
 When installing the Wall-Mount Bracket, do not use
the screws removed from the Table-Top Stand.
 Be sure to store the removed screws and unused
parts in a safe place, keeping them away from
children.
WARNING
 Be sure the TV is on the vertical position before
switching on. TV set must not powered on with LCD
panel face down to avoid uneven picture uniformity.
 If pressure or shock is applied to the surface of the
TV, the TV may break or become damaged.
 Lay the TV face down on a stable and level surface
with the Table-Top Stand hanging over the edge of
the surface. Having the TV face and the base of the
Table-Top Stand on the same level surface will create
an unstable working condition and can damage the
TV.
 When detaching the Table-Top Stand from the TV,
hold the Table-Top Stand securely.
2
Attach the Attachment parts for
Wall-Mount Bracket. Check the
Attachment parts by referring to
"Supplied with SU-WL450" in
"Checking the parts" on page
6.
Note
 Firmly secure the Attachment parts using screws.
 When using an electric screwdriver, set the torque
setting to approximately 1.5 N·m {15 kgf·cm}.
Standard mounting (2-a)
Screw
(+PSW 6 x 20) 
Pulley 
Soft cloth
Slim mounting (2-b)
Note
 You cannot use some of the terminals on the rear of
the TV when using this mounting style.
− 13 (GB) −
Screw
(+PSW 6 x 50)

Spacer
(60 mm)

Belt 
GB