Maintenance; Daily Maintenance; Replacing Tension Pneumothorax Bladder - Laerdal SimBaby Mode D'emploi

Daily Maintenance

Warning: Ensure that compressed air is not present in the
simulator when training session is over.
To Clean the Simulator
Clean simulator skin with mild soap and water. Make sure that no
water gets inside the simulator. Do not submerge simulator.
SimBaby Clothing
Note: For washing instructions see care labels.
Modules and all other parts
Modules and all other parts should be drained, flushed through with
water and air-dried thoroughly prior to storage. Disinfectants should
be used where appropriate.
Esophagus Filter Assy
Replace Esophagus Filter assy after each session (see Maintenance
section for details).
Lower Legs
Replace lower legs if IV/IO skills have been practiced.
Storage
Store properly between teaching sessions. If stored in hard cases
disconnect cables and tubings.
Air Filter
The air filter in the compressor should be replaced every two years.
Directions for replacement are part of the Technical/Service manual.
Replacing Tension Pneumothorax
Bladder
To replace bladder
Remove skin at torso sides and loosen inside tap at the umbilical
area from its seat.

MAINTENANCE

Lift the chest plate assy exposing its underside.
Disconnect bladder hose from the nipple.
Remove bladder from site cavity by sliding it sideways out of the
chest.
Insert new Pneumothorax Bladder into site cavity and reconnect
to the nipple.
Replace chest plate assy.
Replace chest skin over torso, fasten the tap inside the skin to its
seat and secure skin at the shoulders and both sides.
13