Selve commeo Multi Send BASIS Notice page 82

General section (BASIS and PREMIUM)
2.2. SELVE-commeo-radio
The SELVE-commeo-radio system transmits and receives radio signals on a frequency of
868.1 MHz.
commeo is a bidirectional radio system that allows data to be stored in both the transmitter
and the receiver. Resetting the receiver or deleting the transmitter list causes the transmitter
to issue an error message.
All commeo transmitters can be taught in the drives/receivers. Up to 16 transmitters can be
taught in a single drive/receiver. Observe the operating instructions for the drives/receivers.
3. commeo Multi Send KonfigTool
The commeo Multi Send KonfigTool is a soft-
ware program that runs on a PC or laptop
(Windows or macOS).
All settings in commeo Multi Send can also be
easily adjusted in the KonfigTool. The clear
display and simple keypad entry make config-
uring the commeo Multi Send easy. To do so,
connect the commeo Multi Send to the PC/
Mac via a USB data cable.
Download the KonfigTool at www.selve.de/commeomultisend
3.1. Downloading and installing the commeo Multi Send KonfigTool
The commeo Multi Send KonfigTool can only be downloaded via the SELVE website:
www.selve.de/commeomultisend
The tool can be installed in any file and requires no administrator rights. To start the Konfig-
Tool, double click on the file "MultiSendControlCenter.exe".
Note: The file "MultiSendControlCenter.exe" is linked to a desktop icon with the file
symbol (image).
3.2. Micro USB connection
There is a micro USB socket on the rear side of the commeo Multi Send.
Use a data cable with a micro USB connector (image) to connect.
Note: Do not keep the commeo Multi Send constantly connected to the
PC or laptop via USB. When the commeo Multi Send is connected, it
does not switch to energy saving mode and the batteries deplete very
quickly.
Note: The USB connection cannot be used to supply the commeo Multi Send with power or
charge the batteries.
Note: Some USB cables are only designed for charging, and are not suitable for data transfer.
Pure USB charging cables cannot be used for the software. In this case, the KonfigTool will not
recognise the connected commeo Multi Send.
82