Selve commeo Multi Send BASIS Notice page 109

BASIS version
Automatic sunlight function
This function performs an action for the selected device (e.g. extending
the awning to create shade) based on the intensity of sunlight.
Use the channel selection buttons
Select the "Activity" function using the movement buttons
(down). It is possible to activate/deactivate the automatic sunlight func-
tion.
Use the movement buttons
to between 1 and 3.
Sunny: If the sunlight value measured by the assigned sensor exceeds the set value,
an action is performed for the selected device (e.g. awning extends). Use the
channel selection buttons
20 klux and 100 klux.
Cloudy: If the sunlight value falls below the set value, an action is performed for the
selected device (e.g. awning retracts). Use the channel selection buttons
to adjust the value in steps of 5 klux between 5 klux and 85 klux. The "Cloudy"
value is always at least 15 klux smaller than the "Sunny" value (= hysteresis).
Sun 1–3: The commeo Sensor WS and WSRF have three light measuring units. The aver-
age value of the three units is used for the "Sunny" or "Cloudy" settings.
You can activate or deactivate the light measurement units individually for each
drive.
: Light measurement units function activated.
: Light measurement units function deactivated.
Note: Scattered light can lead to overlaps.
Note: The lower section of the display shows the light values currently measured
by the three light measurement units.
: Automatic sunlight function activated.
: Automatic sunlight function deactivated.
(up) and (down) to set the values for "Sunny" and "Cloudy"
or to adjust the value in steps of 5 klux between
109
or to select the sun symbol.
(up) and
or
EN