Burglar Zones; Acknowledging An Alarm - Agri-Alert 9600 Mode D'emploi

1.6 BURGLAR ZONES

These zones are armed or disarmed as a group using a password. In a delay burglar
zone, alarm conditions are not signalled until a delay has elapsed. The Exit Delay
allows the user to leave the building while arming the system. The Entry Delay allows
the user to enter the building and disarm the system without setting off an alarm.
Stay arming zones allow the user to move about inside the building while protecting
the perimeter, i.e. windows and entry points. If the system is armed and no one has
left the building within the exit delay, stay arming zones are bypassed by the system.
The key sequence for arming or disarming is as follows:
6
0 9 0 0
followed by the password sequence
Output Entry/Exit Delay
Arm/Disarm Arm/Disarm Arm/Disarm
0
For quick arming, press
*
Enter Arm/Disarm
If force arming is disabled, all burglar zones must be in a normal state to arm the
system, i.e. no alarm conditions must be present. If the arming sequence fails, zones
with alarms are listed on the display .
When the system is armed, the system starts beeping and the screen immediately
displays a countdown of the exit delay (in minutes and seconds). The keypad is
locked at this point: the only key sequence allowed is the disarming sequence. After
the exit delay has elapsed, the system is armed and alarms are immediately declared
as they are detected for all burglar zones. The system displays the message "BUR-
GLAR ZONES ARMED" periodically on the screen.
When an alarm occurs in a burglar zone with an entry delay, the screen displays a
countdown of the entry delay. During this time, the piezoelectric loudspeaker beeps
(the loudspeaker stops when the key sequence is entered). If no one has disarmed
the system after the entry delay has elapsed, an alarm is declared. Disarming will
affect all currently active burglar zones. The system displays the message "BUR-
GLAR ZONES DISARMED" on the screen.

1.7 ACKNOWLEDGING AN ALARM

In order to notify the Agri-Alert system that an alarm message has been received, the
alarm must be acknowledged. There are several ways of doing this. If you are on-
site when an alarm is detected, enter your password (if the password feature is en-
abled) or simply press the "1" key to acknowledge. You can also acknowledge an
alarm over the phone when the Agri-Alert system reports the alarm (see below) or by
calling the Agri-Alert system yourself between phone dialouts (if the intercall time is
greater than zero).
9
KP-400.rev.06