Copying Zone Set Points To Another Zone - Agri-Alert 9600 Mode D'emploi

3.3.6 Copying Zone Set Points to Another Zone

Definition: The user can copy the high set point, the low set point, the critical tem-
perature and the curve points from an existing zone to another zone of the same type
(or to several zones). This avoids repeating the same sequence several times.
Note that the curve parameters can only be copied/pasted if the operation is per-
formed from the AA-9600 unit. If the operation is made from a keypad module, only
the set points and the critical temperature will be copied/pasted.
Setting:
1. Follow the procedure above (3.3) and press Enter
The zone selected on section 3.3 is the reference zone from which the set points will
be copied.
COPY SET POINTS
ZONE # 3
PASTE TO
ZONE(S): _ _ _ _ _
2. Enter the zone(s) on which the set points of the reference zone will be pasted on
and press Enter. To paste the set points to more than one zone at once, you can enter
a range: 10-20, for example, using the
ADD ZONE. . . . . . . . . . (1)
TO CONTINUE . . . . . . . .
(2)
3. Type 1 to paste the set points of the reference zone to another zone using the
same model; type 2 to complete the operation. Press Cancel to quit this function.
ENTER
key to enter the dash.
TROUBLE
+ / -
at COPY/PASTE.
KP-400.rev.06
27