Adjusting Set Points - Agri-Alert 9600 Mode D'emploi

The temperature curve status is displayed only if the zone has been
configured with a temperature curve. If the curve is currently activated,
the offset values are also displayed and the set points displayed are
calculated according to the curve settings.
The critical temperature is displayed only if the outdoor temperature
compensation feature is activated.
You can reset the minimum and maximum temperature values displayed
by pressing 1 while the minimum and maximum values are displayed.
5. Press Enter
quit.
ZONE #1
SET POINTS
6. User-adjustable parameters are displayed in a scrolling menu. Use the arrow keys
to scroll the menu to the desired parameter and press Enter
Previous / Next
quit, press Cancel

3.3.1 Adjusting Set Points

1. Follow the procedure above (3.3) and press Enter
SET POINTS
LO: 55.0°F, HIGH: 85.0°F
RANGE FROM
(-40
LO SET POINT
_ _ _ _
2. This is the lower value of the normal temperature range. It ranges from -40
149 F (-40 C to 65
o o
and press Enter. To enter a negative value, use the
after the digits.
to modify the current set points or Cancel
ENTER
.
#
Cancel
F .. 149 F)
o o
F
o
C) with an accuracy of 0.1
o
ENTER
F (0.1 C). Enter the low set point
o o
key, either before or
TROUBLE
+ / -
#
to
Cancel
. To
ENTER
at SET POINTS.
F to
o
KP-400.rev.06
21