Adjusting Curve Points - Agri-Alert 9600 Mode D'emploi

3.3.3 Adjusting Curve Points

1. Follow the procedure above (3.3) and press Enter
The following parameters can only be accessed if the zone has been
configured with a temperature curve.
POINT #1
DAY ,
2. Use the arrow keys
.
ENTER
Note that the first curve point is always at day 1.
POINT #2
DAY:_ _ _
3. Enter the day number for the point selected and press Enter
POINT #2
TEMP.:_ _ _ _ _°F
4. Enter the corresponding temperature value for that day and press Enter
POINT #2
DAY 10,
5. Select another point to edit using the arrow keys. At least two points must be
defined in order to use the curve. Note that the curve must be enabled in a separate
sequence (see Section 3.3.4). To finish programming the curve, press Cancel
#
.
Cancel
50.0 °F
to select the point to edit (1 to 10) and press Enter
Previous / Next
75 . 0 °F
at POINTS.
ENTER
ENTER
KP-400.rev.06
.
.
ENTER
25