16.3
Storage
Store the machine in a dry, frost-proof and lockable place when not in use. Make sure that unauthorised
persons and especially children do not have access to the machine.
Improper storage can damage and destroy important components. Only store packed or
already unpacked parts under the intended ambient conditions!
16.4
Disposal
Observe the national waste disposal regulations. Never dispose of the machine, machine
components or operating equipment in the residual waste. If necessary, contact your local
authorities for information regarding available disposal options.
If you purchase a new machine or equivalent equipment from your specialist dealer, he is
obliged in certain countries to dispose of your old machine properly.
17
TROUBLESHOOTING
Dangerous electrical voltage!
The machine may only be connected to the mains supply and the associated
checks carried out by a qualified electrician or under the instruction and supervision
of a qualified electrician!
Many possible sources of error can be eliminated in advance if the machine is properly connected to the
mains. If you are unable to carry out the necessary repairs properly and/or do not have the required training,
always consult a specialist to solve the problem.
Trouble
Machine doesn't start
Workpiece kick-back
Wrong cutting angle
ZIPPER MASCHINEN GmbH
www.zipper-maschinen.at
N O TE
WAR N I N G
Possible cause
•
No power supply
Carbon brushes defect
•
•
Motor defect
ON-OFF-switch defect
•
Dull saw blade
•
•
Wrong assembled saw blade
Angular position not correct
•
TROUBLESHOOTING
Solution
•
Connect to mains
Contact the service team
•
•
Contact the service team
Contact the service team
•
Replace saw blade
•
•
Check direction / assembly
Adjust the angular position
•
45
ZI-KGS210DS