Settings; Fine Adjustment Fence - Zipper ZI-KGS210DS Mode D'emploi

Deviation of the supply voltage and frequency!
A deviation from the value of the supply voltage of ±5 % is permissible.
A short-circuit fuse must be provided in the power supply system of the machine!
Use a supply cable of type H07RN (WDE282) or take the required cross-section of the supply
•
cable from a current carrying capacity table. Pay attention to the measures for protection
against mechanical damage.
• Make sure that the power source is protected by a residual current circuit breaker.
Connect the device only to a properly grounded outlet.
•
When using an extension cable, make sure that the dimension matches the connected load of
•
the machine. The connection power can be found in the technical data, the correlation of cable
cross-section and cable lengths can be found in the technical literature or obtain information
from a specialist electrician.
A damaged cable must be replaced immediately.
•
14.4

Settings

14.4.1

Fine adjustment fence

ZIPPER MASCHINEN GmbH www.zipper-maschinen.at
•
N O TE
• Press the machine head downwards and fix it by
inserting the locking bolt (1).
• Fix the rotary table in the 0°-position with the mitre lock
(2).
• Place a 90° stop angle (3) on the saw blade (4) and
against the fence (5).
• Loosen the screws (6) at both sides with an Allen key and
align the fence at an angle of 90° to the saw blade.
• After adjustment, retighten the screws (6).
•
ASSEMBLY
36
ZI-KGS210DS