Fine Adjustment Of The Angular Position 90° (By Means Of Stop Angle); Fine Adjustment Of The Angular Position 45° (By Means Of Stop Angle) - Zipper ZI-KGS210DS Mode D'emploi

14.4.2 Fine adjustment of the angular position 90° (by means of stop angle)
14.4.3 Fine adjustment of the angular position 45° (by means of stop angle)
Inclination angle left
Inclination angle right
ZIPPER MASCHINEN GmbH www.zipper-maschinen.at
• Fix the rotary table in the 0°-position with the mitre lock.
• Release the locking lever (1) and set the machine head
with the handle to the 0°-position (2).
• Secure the machine head with the locking lever (1) again.
• Place a 90° stop angle (2) between the saw blade and the
rotary table.
• Use the adjusting screw (4) to set the angle between the
saw blade and the turntable to 90°.
• Then check the position of the angle indicator (3, 5).
• If necessary, loosen the screw (6) with a Phillips
screwdriver and move the pointer (3) to the exact
position 0° on the vertical angle scale (5) and then fix it
again.
• Lower the machine head and fix it with the locking bolt.
• Fix the rotary table in the 0°-position with the mitre lock.
• Adjusting the 45° angle on the left: Release the locking
lever (1) and tilt the machine head with the handle to the
left into the 45° position then secure it again with the
locking lever (1).
• Place a 45° stop angle (2) between the saw blade and the
rotary table.
• With the adjusting screw (2) the saw blade is set at an
angle of 45° to the turntable.
• Adjusting the 45° angle on the right: Release the locking
lever (1) and tilt the machine head with the handle to the
ASSEMBLY
37
ZI-KGS210DS