Sliding Cuts; Slot Cuts; Cleaning, Maintenance, Storage, Disposal; Cleaning - Zipper ZI-KGS210DS Mode D'emploi

15.3.2

Sliding cuts

Sliding cuts are suitable for cutting longer workpieces.
15.3.3

Slot cuts

Set the depth stop for slot cuts so that the desired cutting depth is obtained at the selected angle.
Make the mitre or sliding cuts as described in the respective chapter with the difference that the
workpiece is not completely cut through.
16

CLEANING, MAINTENANCE, STORAGE, DISPOSAL

Dangerous electrical voltage!
 The machine may only be connected to the mains supply and the associated
checks carried out by a qualified electrician or under the instruction and supervision
of a qualified electrician!
16.1

Cleaning

Regular cleaning guarantees the long service life of your machine and is a prerequisite for its safe
operation.
ZIPPER MASCHINEN GmbH www.zipper-maschinen.at
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
• For that kind of cuts, the sliding mechanism is unlocked
by releasing the drag lock (1) so that the machine head
can slide forwards or backwards during the cut.
• Adjust the angle setting according to the desired
operation and adjust the fences accordingly.
• Mark the cutting line (by laser).
• Place the workpiece against the fence and table and fix it
with the clamp device (2).
• Move the machine head to its uppermost position.
• Switch on the machine and wait until the saw blade has
reached full speed.
• Perform a sliding cut: To do this, push the machine head
forward, then move it downward evenly with light
pressure until it reaches the lowest position. Then push
the machine head slowly and evenly backward to process
the entire length of the workpiece.
• Move the machine head to the uppermost position.
Machine head is spring loaded, do not simply
release the machine head, instead move the
handle upwards until the uppermost position is
reached (rest position).
• Release the ON-OFF switch and wait until saw blade
comes to stand still.
• Remove workpiece.
WAR N I N G
N O TE
41
ZI-KGS210DS