Transport; Locking / Unlocking The Machine Head - Zipper ZI-KGS210DS Mode D'emploi

A safety note designed in this way indicates a potentially dangerous situation which, if
not avoided, may result in property damage.
Regardless of all safety regulations, your common sense and your appropriate technical aptitude/training
are and remain the most important safety factor in the error-free operation of the machine. Safe working
depends on you!
13

TRANSPORT

For proper transport, also observe the instructions and information on the transport packaging regarding
centre of gravity, lifting points, weight, means of transport to be used as well as the prescribed transport
position etc. Ensure the correct body posture when lifting, carrying and setting down the load.
Lifting / Setting down
• When lifting/setting down, ensure that you are standing firmly (legs hip-width apart).
• Lift/set down load with knees bent and back straight.
• Do not lift/set down load with a jerk.
Carrying
• Carry load with both hands as close to body as possible.
• Carry load with straight back.
NOTE:
Transport of the unpacked machine only in transport position = saw unit in the lower position
and locked by means of bolt as well as drag lock locked.
Transport of the assembled machine
ZIPPER MASCHINEN GmbH www.zipper-maschinen.at
N O TE
• Tighten the mitre lock (1) to fix the rotary table.
• Fix the machine head in the rear position using
the drag lock (2).

Locking / unlocking the machine head

• By slightly pressing down the machine head and
simultaneously removing the locking bolt (3) from the
motor holder, the saw is released from the lowest /
transport position.
NOTE:
Please hold the handle and guide the machine head
slowly upwards until it reaches the uppermost position. If the
handle is released, the machine head will jump up due to the
spring preload.
• Press the machine head downwards and fix it by
inserting the locking bolt (3).
• The machine can be carried at both sides of the fixed
work table (4).
TRANSPORT
33
ZI-KGS210DS