Operation; Initial Check Before Start; Setting The Angular Position Of The Worktable - Zipper ZI-KGS210DS Mode D'emploi

15

OPERATION

Only operate the machine when it is in a perfect condition. Before each operation, a visual inspection of
the machine must be carried out. Safety devices and operating elements must be checked carefully.
Check screw connections for damage and tight fit.
15.1

Initial check before start

Check that the speed of the machine is lower than the max. permissible speed of the saw blade
•
used.
Check saw blade rotation and saw blade dimensions to match the machine.
•
Check that the saw blade guard works properly.
•
Check whether the connection to a dust collection system is installed.
•
Check whether the stops/fences are set correctly and the saw blade is tightened.
•
• Check whether the machine is fixed on the working plate or a machine stand.
• Check whether the saw blade can run freely.
15.2 Operation
15.2.1

Setting the angular position of the worktable

ZIPPER MASCHINEN GmbH www.zipper-maschinen.at
right into the 45° position then secure it again with the
locking lever (1).
• Place a 45° stop angle (2) between the saw blade and the
rotary table.
• With the adjusting screw (3) the saw blade is set at an
angle of 45° to the turntable.
• Loosen the mitre lock (1) to set the rotary table to the
desired angle.
• At the locking positions, in angles -45°, -31.6°, -22.5°, -15°,
0°, 15°, 22.5°, 31.6° and 45°, the turntable audibly engages.
• The angular position is indicated at the mitre angle scale
(3) by means of the indicator (2).
• Fix the rotary table again with the mitre lock (1).
OPERATION
38
ZI-KGS210DS