Mixing Instructions - Maruyama MCV31R Manuel Du Propriétaire Et De L'utilisateur

Fuel Mixture Chart
Gasoline
1 gallon
2 gallons
5 gallons
1 litre
5 litre

Mixing Instructions

IMPORTANT: Never mix gasoline and oil directly in the Chain Saw fuel tank.
1. Always mix fuel and oil in a clean container approved for gasoline.
2. Mark the container to identify it as fuel mix for the Chain Saw.
3. Use regular unleaded gasoline and fill the container with half the required amount of gasoline.
4. Pour the correct amount of oil into the container then add the remaining amount of gasoline.
5. Close the container tightly and shake it momentarily to evenly mix the oil and the gasoline before filling the
fuel tank on the Chain Saw.
6. When refilling the Chain Saw fuel tank, clean around the fuel tank cap to prevent dirt and debris from entering
the tank during cap removal.
7. Always shake the premix fuel container momentarily before filling the fuel tank.
8. Always use a spout or funnel when fueling to reduce fuel spillage.
9. Fill the tank only to within 1/4-1/2 inch (6 mm-13 mm) from the top of the tank. Avoid filling to the top of the
tank filler neck.
50:1 2-cycle oil
2.6 oz.
5.1 oz.
12.8 oz.
20ml
100ml
— US-24 —