Maruyama MCV31R Manuel Du Propriétaire Et De L'utilisateur page 31

CHECKING THE NON-MANUAL CHAIN BRAKE
1. Stop the engine of the chain saw.
2. Operate the front and rear handles with hands, so that the chain saw may be placed at the height of about 0
~15cm as shown in Fig.
3. Softly detach the left hand from the front handle, and touch the end of the guide bar against the log or the like
placed below so that the machine receives an impact.
Do not let your hand off from the rear handle.
4. The brake should activate when the guide bar hits the log.
5. If the chain brake does not function properly, take the saw to your local Service Center.
0~15cm
— US-30 —