Saw Chain Maintenance - Maruyama MCV31R Manuel Du Propriétaire Et De L'utilisateur

SAW CHAIN MAINTENANCE

Following is a list of recommended cutting equipment for the Maruyama chain saw models MCV31R.
The combinations of power equipment, guide bar and saw chain have been tested and found to be in
accordance with the kickback and vibration requirements of ANSI B175.1–2000.
The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the
corresponding maximum nose radius of a solid bar.
The following list is Maruyama's recommendations. There may be other combinations available, which will
also achieve kickback reduction.
As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our
list. For guide bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number
of sprocket teeth may be considered to have equivalent kickback energy.
When replacing the saw chain, identify the type of chain with the drive links mark.
The following combinations may be used on MCV31R.
Type of chain Chain P/N
91PX045E
Oregon 91PX
91PX052E
Type of bar
Oregon Double 120SDEA041
Guard 140SDEA041
Round file
Low-kickback saw chain is chain that has met the kickback performance requirements of ANSI B
175.1 - 2000(current revision of standard) (American National Standard for Power Tools-Gasoline-
Powered Chain Saws-Safety Requirements) when tested on the representative sample of chain saws
below 3.8 c.i.d. specified in ANSI B 175.1- 2000(current revision of standard).
LOW-KICKBAKCK SAW CHAIN
Drive link number
45 (12 inch bar)
52 (14 inch bar)
LOW-KICKBAKCK GUIDE BAR
Bar P/N Length
12 inch
14 inch
φ4.0mm(5/32inch)
Pitch
3/8 inch
(9.53mm)
Pitch
3/8 inch
(9.53mm)
Right hand cutter
Rivet
— US-35 —
Gauge Drive link mark
0.050 inch
(1.27mm)
Thickness of drive Max. number of teeth
links in the nose sprocket
0.050 inch
(1.27mm)
Left hand cutter
Depth gauge
Drive link Tie strap
7