Faults; Installation Instructions - Atag WG3 Mode D'emploi & Instructions D'installation

faults

Please check the following points which may solve the problem, before calling the service
department.
If the connection cable is damaged, it should be replaced by the service department of the
manufacturer or similarly qualified persons in order to prevent dangerous situations from arising.
NB: Disconnect the appliance from the mains before starting any repairs, preferably by removing
the plug from the socket or by setting the isolation switch to zero.
fault
Lighting does not work.
Extractor hood makes a
lot of noise.
No extraction.
GB 4
cause
Lamp defective.
Discharge duct too long or
has too many bends.
Motor defective.
Motor or controls defective.
Connection lead defective.
solution
Pull the inner ring downwards
using a screwdriver (see
illustration).
NB: the glass is loose!
Pull the halogen lamp out of the
fitting and replace it with a new
20 W halogen lamp. Use a clean
cloth to hold the new lamp.
Change the discharge duct (see

installation instructions).

Phone the Service department.
Phone the Service department.
Phone the Service department.