Faults - Atag ES9011QM Mode D'emploi

faults

If the appliance does not work properly, this does not always mean that it is defective. First, try to
correct the fault by consulting the table below. If you cannot find an answer here, phone the Service
Department.
If the connection cable becomes damaged, it should be replaced by the manufacturer's service
department or by a person with equivalent qualifications, in order to prevent dangerous situations
from arising.
Attention: Disconnect the appliance before starting with cleaning or reparation. Preferably by taking
the plug out of the socket or by turning off the mains switch.
fault
Lighting does not work.
Extractor hood makes a lot of
noise.
No extraction.
GB 4
cause
Lamp defective.
1
2
Discharge duct too long or has
too many bends.
Motor defective.
Motor or controls defective.
Connection lead defective.
solution
Change the light bulb.
- Gently press the front side of
the window (1) and it should
tilt open slightly (2).
- Open the window fully and fit
a new 20 W halogen bulb.
Note: do not touch the bulb's
glass with your fingers.
- Gently push the window
closed again.
Change the discharge duct
(see installation instructions).
Phone the Service department.
Phone the Service department.
Phone the Service department.