Turning On The Appliance; Adjusting The Steam Quantity; Refilling Water - SilverCrest SDR 1500 A1 Instructions D'utilisation

Illustration
To detach the accessory parts, press
the unlocking button (B2 or E2), and
pull the items apart.
Fill up with water
Note: If you always use usual commercial
distilled water it is not necessary to descale
the boiler.
Caution
Do not use condensation water from the
drier!
Do not fill in detergents or other additives!
Remove the safety cap (A4) from the
device.
Empty remaining water from boiler.
Fill the boiler with a minimum of 0.2 litres
and a maximum of 1.0 litres of fresh tap
water
Note: You can cut down the heating-up
time by using warm water.
Screw the safety cap (A4) back onto the
device.

Turning on the Appliance

Place the unit securely on a firm sur-
face.
Caution
The appliance must not be carried during
cleaning.
Insert the mains plug (A7) into a socket.
Both indicator lamps (A2/A3) must illu-
minate.
Caution
Do not turn the appliance on without water
in the boiler. Otherwise, the appliance may
overheat (see Help with faults).
The orange indicator lamp (A3) goes
out after approximately 7 minutes.
The steam cleaner is ready to use.
Push the steam switch lock (B3) to the
back.
Note: If you push the lock forward, the
steam switch cannot be actuated (child
control).
All manuals and user guides at all-guides.com
– Switch in front position: no steam (child
– Switch in middle position: reduced
– Switch in back position: maximum
Water needs to be filled into the boiler, if the
steam volume decreases during work and
no more steam is emitted in the end.
Note: The safety lock (A4) cannot be
opened as long as slight pressure remains
in the boiler.
A residual amount of steam may be emitted
when you open the safety lock. Be careful
when opening the safety lock, there is a risk
of scalding.
Operate the steam switch (B4) and di-
rect the emerging steam jet to a cloth
until the steam emerges evenly.
Note: The heating of the steam cleaner
is turned on in regular intervals during
the operation of the appliance in order
to maintain the pressure in the boiler at
a constant level. When the heating is
turned on, the orange indicator lamp
(heater) lights up.

Adjusting the Steam Quantity

Use the steam switch (B4) to regulate
the discharged steam.
The lock of the steam switch (B3) also
allows for steam volume regulation.
control)
steam amount
steam amount

Refilling Water

Disconnect the mains plug (A7) from
the socket.
Push the steam lever (B4) until steam
discharge stops. Now, the boiler of the
appliance is unpressurized.
Remove the safety cap (A4) from the
device.
Danger
Fill the boiler with a minimum of 0.2 litres
and a maximum of 1.0 litres of fresh tap
water
English 17