Operation - SilverCrest SDR 1500 A1 Instructions D'utilisation

Caution
Make sure that the power cable or ex-
tension cables are not damaged by run-
ning over, pinching, dragging or similar.
Protect the power cable from heat, oil,
and sharp edges.
Never fill solvents, solvent-containing
liquids or undiluted acids (e.g. deter-
gents, benzene, paint thinner, and ace-
tone) into the water reservoir as these
substances affect the materials used on
the appliance.
The appliance must provide of a stable
ground.
Use and store the unit only in accord-
ance with the specifications in the de-
scription and/or figure.
The steam switch (B4) must not be
locked during the operation.
Protect the appliance from rain. Do not
store outside.
Symbols on the machine
Steam
CAUTION - Danger of scalding
Safety Devices
Caution
Safety devices protect the user and must
not be modified or bypassed.
Pressure controller
The pressure controller keeps the boiler
pressure during the operation as constant
as possible. The heating is turned off if the
maximum operating pressure of 4 bar is
reached in the boiler and is reactivated in
case of a pressure drop in the boiler due to
steam tapping.
16 English
All manuals and user guides at all-guides.com
Safety thermostat
The safety thermostat turns off the appli-
ance if the boiler thermostat fails and the
appliance overheats.
Please contact your SERVICE PARTNER
to reset the safety thermostat.
Safety lock (A4)
The safety lock seals the boiler against the
steam pressure that builds up in the boiler.
If the pressure controller is defective and
the steam pressure in the boiler rises above
5.7 bars, a pressure control valve in the
safety lock opens, and steam emerges
through the lock to the outside.
Please contact your SERVICE PARTNER
before you put the unit back into operation.
Hot water may drip out of the accessory
parts while you are detaching them! Never
detach accessory parts while steam
streams out - risk of scalding!

Operation

Attaching the Accessories
Illustration
Insert steering roller (A1) and transport
wheels (A8) and let them lock into
place.
Illustration
Connect the required accessories to the
steam gun (B1).
Insert the open end of the accessory on
the steam gun and push onto the steam
gun until the unlocking button (B2) of
the steam gun locks into place.
Illustration
Use the extension pieces (E1) if neces-
sary. To do so, connect one or both ex-
tension pieces to the steam gun (B1).
Insert the required accessories on the
free end of the extension piece.
Removing the Accessories
Danger
Push the steam lever locking (B3) to the
front (steam switch blocked).