Basic Information Concerning Safety - Hilti PMP 32 Mode D'emploi

5.1 Basic information concerning safety

In addition to the information relevant to safety given in each of the sec-
tions of these operating instructions, the following points must be strictly
observed at all times.
5.2 Correct use of the tool
When used for outdoor applications, care must be taken to ensure that the
conditions under which the tool is used correspond to the conditions encoun-
tered indoors.
Examples of applications:
Transferring points marked on the floor to the ceiling for drywall tracks.
●
Transferring points marked on the floor to the ceiling for pipe hangers.
●
5.3 Misuse of the tool
Do not use the tool unless its accuracy has been previously checked.
●
The tool and its ancillary equipment may present hazards when used
●
incorrectly by untrained personnel or when used not as directed.
Do not open the casing of the tool.
●
To avoid the risk of injury, use only original Hilti accessories and addi-
●
tional equipment.
Modification of the tool is not permissible.
●
Observe the information printed in the operating instructions concern-
●
ing operation, care and maintenance.
Do not render safety devices ineffective and do not remove information
●
and warning notices.
Keep laser tools out of reach of children.
●
Have the tool repaired only at a Hilti service center. Failure to follow the
●
correct procedures when opening the tool may cause emission of laser
radiation in excess of class 2.
Printed: 07.07.2013 | Doc-Nr: PUB / 5070095 / 000 / 00
en