Examples Of Applications - Hilti PMP 32 Mode D'emploi

-NOTE-
The tool switches itself off automatically after approx. 15 minutes.
7.1.3 Deactivating the automatic cut-out
1. Press and hold the selector button (approx. 4 seconds) until the LED on
the tool blinks three times in confirmation.
-NOTE-
The tool will be switched off when the selector button is pressed or when
the batteries are exhausted.

7.2 Examples of applications

7.2.1 Vertical alignment (plumbing) of sections of a steel structure
7.2.2 Aligning pipe fastenings
7.2.3 Vertical alignment (plumbing) of an elevator rail
7.3 Operating status indicators
7.3.1 LED
The LED doesn't light.
The LED lights constantly.
The LED blinks.
Printed: 07.07.2013 | Doc-Nr: PUB / 5070095 / 000 / 00
The tool is switched off.
●
The batteries are exhausted.
●
The batteries are inserted
●
incorrectly.
The laser beam is switched on.
●
The tool is in operation.
The batteries are almost
●
exhausted.
The temperature of the tool is
●
above 40 °C (104 °F) or below –
en