Hilti PMP 32 Mode D'emploi page 19

-CAUTION-
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and may radi-
ate radio frequency energy. Accordingly, if not installed and used in accor-
dance with the instructions, it may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a partic-
ular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by taking the fol-
lowing measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment to an outlet on a circuit different from that to
which the receiver is connected.
– Consult your dealer or an experienced TV/radio technician for assistance.
Changes or modifications not expressly approved by Hilti could limit the
user's right to operate the equipment.
Labels
LASER RADIATION - DO NOT
630-640nm/0.95mW max.
CLASS II LASER PRODUCT
This Laser Product
Complies with 21 CFR
1040 as applicable
Printed: 07.07.2013 | Doc-Nr: PUB / 5070095 / 000 / 00
Made in Malaysia
Hilti = registered trademark of Hilti Corporation, Schaan, LI
STARE INTO BEAM
Power:
Item No.:
Manufact.:
1/4 s
PMP 32
6V / 50 mA
319975
04-2006
en