Install the Batteries
Your multimeter is powered by four 1.5 V AAA
alkaline batteries (included with the shipment).
1 Turn the multimeter OFF and
2 Loosen the screw on the battery
3 Remove the battery cover and
4 Insert the batteries and replace the battery
Turn On the Multimeter
Controlling the Multimeter Remotely
separately), and the Keysight GUI Data Logger
Software.
4
remove the test leads from the
terminals.
cover with a suitable Phillips
screwdriver.
observe the polarity markings.
cover and screw.
To PC
(host)
Keysight U1231A/U1232A/U1233A Quick Start Guide
To power ON your
multimeter, turn the rotary
switch to any other
position.
Your multimeter is
capable of remote data
logging.
To use this feature, you
will need a PC running a
Windows operating
system, an IR-USB cable
(U1173A, purchased