R&G LP0187SS Mode D'emploi page 9

Picture 39
FITTING INSTRUCTIONS

To fit the R&G tail tidy, remove the seat using the key as shown in picture 1.

Remove the plastic undertray on the underside of the tail by removing the four bolts, as arrowed in
picture 2 and shown in picture 3.

Remove the three bolts as arrowed in picture 4.

On the side panel on the right side of the bike, remove the top mounting bolt shown in picture 5
and the lower mounting bolt as arrowed in picture 6.

The side panel can now be pulled off its rubber mounts and removed from the bike, as shown in
picture 7.

Remove the two bolts that secure the rear mudguard to the rear subframe, as shown in picture 8.

With the subframe now loose, remove the top hat spacers from the front mounting holes, as shown
in picture 9, as these will be required when re-fitting.

Remove the two small button head bolts from the sides of the rear mudguard that bolt into the
subframe on both sides of the bike, as shown in picture 10.
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
Picture 41
R&G Racing
www.rg-racing.com Email:
Picture 40
info@rg-racing.com