R&G LP0187SS Mode D'emploi page 11


Take the No. plate illuminator connecter (item 6 – CON0014) and connect the bullet connectors to
the connectors on the no. plate illuminator wiring – black to black and yellow to red, as shown in
picture 29.

With all wiring now on the tail tidy, use the self-adhesive clips (item 12) and cable ties (item 11) to
neatly route the wiring on the top side of the tail tidy.

Take the tail tidy assembly and sit it on the rear wheel whilst feeding the wiring between the cross-
brace on the subframe and rear light, as shown in picture 30.

Re-connect the wiring to the original connectors and check for the correct operation of all lights.

Take the tail tidy cover (item 10 – TB0187 Part 2) and offer up to the underside of the tail as
shown in pictures 31 & 32. The front mounts (the holes that are widest apart) need to locate
between the subframe and aluminium mudguard, with the sides of the cover sitting against the
foam previously fitted to the sides of the aluminium mudguard, as shown in pictures 32 & 33.

With the cover correctly positioned, re-fit the OEM top spacer and OEM bolt through the
mudguard mounting hole, then through the cover mounting hole and tighten into the threaded boss
on the subframe, as shown in pictures 33 & 34.

Feed the wiring up between the subframe and light whilst offering the tail tidy into place on the
underside of the aluminium mudguard and fit the two M8 x 16mm long button head bolts (item 14)
through the tail tidy mounting holes, then through the mounting holes in the cover and loosely
tighten into the threaded bosses on the subframe, as shown in pictures 35 & 36.

Fit the M5 x 12mm long button head bolt (item 16) through the remaining mounting hole and
tighten into the J-clip on the aluminium mudguard, as shown in picture 37.

Ensure the tail tidy is correctly fitted and that the indicators are at the right level before tightening
all bolts evenly, as shown in pictures 38 & 39 and the no. plate illuminator should now sit against
the foam fitted to the underside of the aluminium mudguard, as shown in picture 40.

Re-fit the side panel using the three original bolts, as shown in picture 41.

Re-fit the seat.

Ensure the tail tidy is securely mounted and all bolts are fully tightened.

Re-fit the licence plate (it may require drilling).

Depending on local laws, attach enclosed reflector in an appropriate location.

Test the license plate illuminator and all lights before riding.
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
ISSUE 1 11/02/2016 (AR)
R&G Racing
www.rg-racing.com Email: info@rg-racing.com