4. Connect Waves to the mains
Waves is designed to run continuously and modulate between a minimum airflow rate and the set maximum airflow rate.
The power consumption per hour for Waves varies between 1 and 4.5 watts.
0,25
15 +/- 1
Waves must be connected to a doublepole fuse in the fuse box and is perma
nently live. In a bath or shower room, this fuse must be connected to a circuit
with a circuit breaker with a sensitivity of 30 mA.
5. Place back housing cover and
secure with screws
6mm +/-1
This is where the cable
enters Waves. Please check
if the opening is aligned with
the cable.
6. Place back front cover and
turn clockwise until it clicks
into place
WARNING: Electrical
shock hazard
Failure to turn off the
power may result in serious
electric
shock,
injury
death.
When Waves has just been
connected
to
the
mains,
the local network (name of
WiFi network: Waves_warranty
number) will be active for 40
minutes. If the local network is
not (or no longer) active, press
the blue button.
If you want to manu
ally configure Waves
(i.e. because you have
no smartphone), wait to place
back front cover.
and
61