Eu Declaration Of Conformity - Renson WAVES Manuel D'utilisation

Masquer les pouces

Table des Matières

Les langues disponibles

Safety

• Comply with all safety warnings in

this user's guide. If safety regula

tions are not met, Renson

be held responsible.

• Installation of Waves must be per

formed in accordance with the

general and locally applicable reg

ulations regarding construction,

safety and installation require

ments of the municipal/urban and/

or other bodies.

This user's guide and its contents

is copyright of Renson

. All rights

reserved. Under these copyright

laws, no part of this guide may be

copied for use without the written

consent of Renson

Warranty

2 years

Electrical shock hazard

• Before installing Waves, turn off power to the room where you will install this

device at the circuit breaker or fuse box. Failure to turn off the power before

cannot

installation may result in serious electrical shock, injury or death.

• Do not restore power until Waves is completely installed. Restoring power

before installation is complete may result in serious electrical shock, injury

or death.

• Always wait for a minimum of 30 seconds to reconnect the power supply.

• Improper wiring will cause damage to Waves and may lead to a nonfunc

tioning device.

• Do not disassemble and/or tamper with the product's internal components

as this could damage Waves and cause electric shock resulting in personal

injury.

• Use the device only for applications for which it was designed, as stated in

this user's guide.

• Failure to meet any of the above requirements could damage Waves and

cause it to malfunction.

• Waves must be powered by a 24hour, 230 V AC ±10% (50 Hz, 60 Hz)

circuit. Be sure the circuit cannot be turned off by a switch, a dimmer etc.

Failure to connect Waves to a 24hour circuit will prevent it from providing a

continuous ventilation air flow.

Do not touch the printed circuit board (PCB) due to risk of

malfunction caused by electrostatic discharge.