Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
6.3 Contents
Check the contents to make sure they correspond
with the list of materials as below:
• Positioning unit
• Accessories box
• Label
• Silicone sheath
• Cable ties
• Instruction manual
6.4 Safely disposing of packaging
material
The packaging material can all be recycled. The
installer technician will be responsible for separating
the material for disposal, and in any case for
compliance with the legislation in force where the
device is to be used.
10
6.5 Preparatory work before
installation
6.5.1 Mounting the bracket
Different types of supports are available (10
Accessories, page 17). Choose a suitable bracket for
the installation and follow all the instructions in the
suggested chapter.
Take special care when attaching and
fastening down the apparatus. If it is to be
attached to a concrete surface you must
use dowel pins with a traction torque rating
of at least 300dN each. For a metal surface
use screws with a diameter of at least 8mm
and of an appropriate length. The clamping
system must be able to support at least 4
times the weight of the entire equipment,
including P&T, lenses and camera.
The device should be assembled vertically.
Any other position could impair the
performance of the appliance.
6.5.2 Cables management
The connection cables should not be
accessible from the outside. It is necessary
to fasten the cables securely to the support
in order to prevent excessive weight pulling
them out accidentaly.
You must use cables suited to the type of
installation.
Insert the cables into the support so that they
protrude by about 50cm.
50cm
Fig. 5
50cm
MNVCUCHDB_2104_EN
Publicité
Table des Matières
Dépannage
