Preparing The Product For Use; Contents And Unpacking; Safely Disposing Of Packaging Material; Assembling And Installing - Videotec HEA26 Manuel D'instructions

5 Preparing the product
for use
Any change that is not expressly approved
h g
by the manufacturer will invalidate the
guarantee.

5.1 Contents and unpacking

When the product is delivered, make sure that the
package is intact and that there are no signs that it
has been dropped or scratched.
If there are obvious signs of damage, contact the
supplier immediately.
Keep the packaging in case you need to send the
product for repairs.
Check the contents to make sure they correspond
with the list of materials as below:
• HEA Housing
• Housing equipment:
• Allen wrench
• Spacers
• Cable glands
• Cable glands gaskets
• Screws and washers
• Screws for camera
• Desiccant salt bag
• Instructions manual
5.2 Safely disposing of
packaging material
The packaging material can all be recycled. The
installer technician will be responsible for separating
the material for disposal, and in any case for
compliance with the legislation in force where the
device is to be used.
Bear in mind that if the material has to be returned
due to a fault, using the original packaging for its
transport is strongly recommended.
4
6 Assembling and
installing
Only specialised personnel should be
h g
allowed to assemble and install the device.

6.1 Installation

6.1.1 How to open the housing

To open the housing, unscrew the 2 screws (01)
placed on the side in the middle of the rear cover
plate and take the body (02) out.
01
Fig. 01
Hang the body onto the suitable holder and leave the
internal and external slide in the working position.
Fig. 02
Before closing the housing take off the protective
nylon and put silicagel salts envelope into.
01
02