Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
How to use the USB terminal
This projector can connect to a commercial USB memory device and a USB memory card
reader/writer that are USB2.0 compliant, a digital camera or the like and display the JPEG
and MPEG files saved in those devices.
(Ricoh does not guarantee the operation of all USB 2.0-compliant devices.)
To connect or disconnect a USB device, use the following procedure:
■
Connecting USB device
Plug in the USB device.
Make sure the orientation is correct then plug in the USB device until it is secure.
■
Disconnecting USB device
Switch the input to USB memory and press the MENU button twice to
1
display the Setting display (2), then select and run [Unplug device] in
the Slideshow setting menu.
The process for disconnecting a USB device starts.
The message "This USB device can be unplugged safely" appears on
2
the screen.
Unplug the USB device.
3
CAUTION
•
Be sure to perform the above steps. Disconnecting a USB during operation may
cause a system malfunction or data corruption.
Notes
•
A USB device can be plugged in even when the power is on.
•
The projector may not recognize a supported USB device. If that happens, unplug
the USB device then plug it in again.
•
The USB terminal does not support the supplied mouse remote control receiver or
a commercial mouse controller.
•
A USB hub is not supported.
Precaution
•
Disconnecting the power plug while the USB device is operating may cause a
malfunction or data corruption.
USB device
26
Publicité
Table des Matières
