Setting The Alarm; Volume & Sound; Backlight; Warranty - PERFECTPRO MyTUBE Manuel De L'utilisateur

SETTING THE ALARM

The alarm can only be set when the radio is in standby mode. If no buttons are pressed for 5 seconds, the radio will exit the alarm
setup and the setting is cancelled.
Setting the alarm clock
1. Press the MENU button twice until the display shows "ALARM SET".
2. Press the SELECT/INFO button to enter and the hour digits flash on the display.
3. Press the Tuning Down or Tuning Up button to set the hour.
4. Press the SELECT/INFO button to confirm. The minute digits flash.
5. Press the Tuning Down or Tuning Up button to set the minute.
6. Press the SELECT/INFO button to confirm.
7. The display will then show "ALARM SOURCE". You may choose either "BUZZER" or "FM RADIO". Press the Tuning Down or
Tuning Up button to select. If "FM RADIO" is selected, the last listened station will be played when the alarm rings.
8. Press the SELECT/INFO button to confirm.
9. The display will then show "VOL XX". Press the Tuning Down or Tuning Up button to change the alarm volume.
10. Press the SELECT/INFO button to confirm.
Switching on/ off the alarm
1. To switch the alarm on, press the SELECT/INFO button and hold for 2 seconds. The alarm icon will be shown at the top left
corner. To switch the alarm off, press the SELECT/INFO button again and hold for 2 seconds . The alarm icon will be disappear.
2. To turn off the alarm when it buzzes, simply press the On/Off button.
VOLUME & SOUND
To adjust the volume, simply press the Volume Down or Volume Up button when playing the FM radio or in AUX IN mode. The
level of volume (from 00 to 40 the loudest) will be shown on the LCD Display.
Note: When playing on batteries; if the energy level of the batteries is too low, sound will distort on higher volume.
360 DEGREES SOUND
The unique Neodymium speaker located on top of the radio provides a 360 degrees sound image. Suggestion: If preferred, place the
radio in a corner or close to a wall for additional sound reflection.
11

BACKLIGHT

When the radio is in operation or in standby, pressing any button will illuminate the LCD display for approx. 10 seconds.

WARRANTY

This product has a 2 year limited warranty.
WARNING ! Warranty becomes void once the radio cabinet has been opened !
Batteries, being consumables, do not fall under the warranty conditions of the radio.

SPECIFICATIONS

Power requirements
Mains AC/DC adaptor AC 110-240V 50/60Hz~
Batteries 6 x AM3/AA/LR6
Rechargeable batteries 6 x 1.2V 2500mAH NiMH size AA
(Batteries of Perfectpro brand are highly recommended to be used)
Frequency coverage
FM 87.5 – 108 MHz
Circuit features
Loudspeaker 1 x Ø2 1/4 inch
Output power 1 x 5W Aux In socket Ø3.5 mm
Environmental note:
This product has been made from high-quality parts and materials which can be reused and recycled.
Therefore, do not throw the product away with normal household waste at the end of its life. Take it to a collection point
for recycling electrical and electronic device. This is indicated by this symbol on the product, in the operating manual
and on the packaging.
Please find out about collection points operated by your local authority.
Help protect the environmental by recycling used products.
GB
G B
12