Assembly - RedMax LRT-EX110 Mode D'emploi

To assemble the hand guard and loop
handle (LRT-EX110)
1. Loosen the clutch sleeve's two mounting bolts and
dismantle the clutch sleeve.
2. Assemble the hand guard and loop handle by
screwing them together. Take care to align the holes
in both parts.
3. Slide the loop handle and hand guard onto the shaft.
4. Slide the spacer into the slot in the loop handle.
5. Fit the nut and screw. Do not overtighten.
6. Now make a final adjustment to give yourself a
comfortable working position. Tighten the screw.
6

Assembly

7. Fit the clutch sleeve and tighten the two mounting
bolts.
To assemble the cutting head
It is important that the hedge trimmer is laid on a flat
surface when you fit the cutting head. Otherwise the
cutting head may not be fitted straight.
1. Fit the cutting head to the shaft.
2. Tighten the lower screw first, then the upper screw.
To assemble the handle (LRT-EX850)
1. Install the handle with the 2 screws.
CAUTION: The loop handle and hand
guard must not be fitted behind the
arrow marked on the shaft.
CAUTION: Make sure the drive shaft
inside the shaft engages with the recess
in the cutting head.
442 - 002 -