Maintenance - RedMax LRT-EX110 Mode D'emploi

To change the hedge trimmer angle
(LRT-EX850)
1. Undo the knob.
2. Adjust the angle with the help of the handle on the
cutting unit.
Introduction
Below you will find some general maintenance
instructions. If you need further information please
contact your service workshop.
To perform maintenance on the
attachment
To perform daily maintenance
A
1. Check that the blades (A) do not move when the
engine is idling or when the choke is in the start
throttle position.
2. Check that the hand guard (B) (LRT-EX110) is not
damaged. Replace the guard if necessary.
8

Maintenance

B
3. Tighten the knob.
WARNING: Do not hold the cutting head
when you adjust the angle. The blades
are sharp and you could easily cut
yourself.
To perform weekly maintenance
A
1. Fill the gear housing (A) with grease. New products
are first filled with grease after approximately 20
hours of operation, and subsequently approximately
every 60 hours of operation.
2. Check that the screws that hold the blades together
(B) are correctly tightened.
To lubricate the gear housing
CAUTION: The gear housing must not be
filled completely with grease. The grease
expands as the product heats up during
operation. If the gear housing is completely
filled with grease it can damage the seals
and lead to leakage of grease.
There is a grease nipple and a plug for filling lubricant
on the gear housing.
B
442 - 002 -