Operation - RedMax LRT-EX110 Mode D'emploi

To check before starting
1. Inspect the working area. Remove any objects that
could be thrown out.
2. Check the cutting attachment. Never use blades that
are dull, cracked or damaged.
3. Check that the product is in perfect working order.
Check that all nuts and screws are tight.
4. Make sure the gear housing is lubricated correctly.
To lubricate the gear housing on page 8 for
See
instructions.
5. Check that the cutting attachment stops when the
engine is idling.
6. Only use the product for the purpose it was intended
for.
7. Make sure that the handle and safety features are in
good working order. Never use a product that lacks a
part or has been modified outside its specifications.
To use the attachment
1. Work with a swinging action from the bottom
upwards when trimming sides.
2. Adjust the throttle setting to suit the load.
3. When trimming a hedge the engine should always
face away from the hedge.
4. Hold the product as close to your body as possible to
get the best balance.
5. Make sure that the tip does not touch the ground.
6. Do not rush the work, but work steadily until all the
branches have been cut back cleanly.
442 - 002 -

Operation

To change the hedge trimmer angle
(LRT-EX110)
1. Undo the knob.
2. Press the cutting unit against the hedge or some
other firm surface until the required angle is set.
3. Tighten the knob.
7