Assembly; Operation - RedMax SRTZ235 Manuel D'utilisation

• The exhaust fumes from the engine contain carbon
monoxide, an odourless, poisonous and very
dangerous gas that can cause death. Do not run the
product indoors or in closed spaces.
• The exhaust fumes from the engine are hot and can
contain sparks. Do not run the product indoors or
near flammable material.
• Accessories and changes to the product that are not
approved by the manufacturer, can cause serious
injury or death. Do not change the product. Always
use original accessories.
Introduction
This section describes how to assemble and adjust the
product.
WARNING:
product, read the safety chapter and the
assembly instructions.
To install the handle
• Install the handle with the 2 screws.
To adjust the harness LRTZ235
Always use the harness when you operate the product.
The harness gives maximum control during operation of
Introduction
WARNING:
product, you must read and understand the
safety chapter.
To do before you operate the product
• Examine the work area and remove loose objects.
• Do a check of the cutting unit. Refer to
the blades on page 15 .
8

Assembly

Before you assemble the

Operation

Before you operate the
To examine
• If the maintenance is not done correctly and
regularly, there is an increased risk of injury and
damage to the product.
• Only do the maintenance as this operator's manual
recommends. Let an approved RedMax service
agent do all other servicing.
• Let an approved RedMax service agent do servicing
on the product regularly.
• Replace damaged, worn or broken parts.
the product. The harness decreases the risk of tiredness
in your body.
1. Put on the harness.
2. Attach the product to the harness support hook.
3. Adjust the length of the harness until the support
hook is level with your hip.
• Make sure that the safety devices of the product
operate correctly. Do not use the product without all
safety devices installed correctly.
• Make sure that all screws and nuts are tight.
• Make sure that all covers are attached correctly and
not damaged before you start the product.
• Make sure that the cutting unit stops when the
engine is at idle speed.
Fuel
This product has a two-stroke engine.
1695 - 001 - 24.06.2021