Mains Connection - KERN MCC 250K100M Mode D'emploi

Gap width must not exceed 15 mm!

8.5 Mains connection

Terminal power supply unit
Power is supplied via the external mains adapter. The printed voltage must
correspond to the local voltage.
Only approved genuine KERN power supply units may be used in compliance with
Directive EN 60601-1.
The small sticker attached to the side of the display unit indicates the power port:
The LED remains illuminated as long as the weighing scale remains connected to the
mains. The LED display provides information about the battery's charging status.
Green: battery is fully charged
Blue: battery is charging
MCC-M-BA-e-1616 25