Placing; Mains Connection; Rechargeable Battery Operation (Optional) - KERN MPD 250K100NM Mode D'emploi

7.4 Placing

7.5 Mains connection

only model MPD 250K100NM
Power is supplied by the external power unit which also serves to isolate the mains
supply from the scale. The stated voltage value must be the same as the local
voltage.
Always use genuine approved KERN power pack units.
The small sticker attached to the side of the display unit indicates the power port:
The LED remains illuminated as long as the weighing scale remains connected to the
mains. The LED display informs you during loading about the loading status of the
rechargeable battery.
green: Rechargeable battery completely reloaded
blue: Charging storage battery

7.6 Rechargeable battery operation (optional)

only model MPD 250K100NM
1
Open battery compartment cover (1) at the base of the display unit and insert battery.
Charge the battery for at least 12 hours before initial use.
The appearance of the symbol
is almost exhausted. The weighing scale will remain ready for operation for a few
more minutes before switching off in order to save battery. Load rechargeable
battery.
10
 Level balance with foot screws until the air bubble of the
water balance is in the prescribed circle.
 Check levelling regularly.
in the weight display indicates that the battery
MPD-BAPS-e-1811