StarLab Ergo One Mode D'emploi page 17

– Remove the O-ring
(Fig. 5).
Note: The piston is subject to spring tension.
– Degrease the piston
fectant and re-lubricate the piston with original
STARLAB piston grease (see section 8 Ordering
Information). A damaged piston must be replaced.
– Reassemble the pipette in the reverse order.
14
· ErgoOne · User Manual
, spring and piston
7a 8
using an alcoholic disin-
9
Replacing seals for models up to 1000µl
– Remove the spacer ring
1000µl models) (Fig. 5).
– Remove the sealing ring
using the auxiliary tool (Fig. 6) and replace it (see
section 8 Ordering Information for replacement
sealing ring).
– Reassemble the pipette in the reverse order.
Fig. 6
9
Fig. 5
(only 100µl, 200µl and
11
from the tip holder
10