Installation - Wolf ICBDF30450/S/P Guide D'installation

Installation

Dual Fuel Range
INSTALLATION
330 457
mm mm
152
mm
937 mm
TO COOKING
SURFACE
ELECTRICAL
AND GAS IN
'A' LOCATION
ONLY
SIDE VIEW
51
mm
*Without ventilation hood, 914 mm minimum clearance countertop to combustible materials, 1200 mm for chargrill (broiler).
NOTE: Shaded area above countertop indicates minimum clearance to combustible surfaces.
Combustible materials cannot be located within this area.
For island installation, 305 mm minimum clearance back of range to combustible rear wall above countertop.
OPENING WIDTH W
762 mm Range 762 mm
914 mm Range 914 mm
1219 mm Range 1219 mm
1524 mm Range 1524 mm
AUSTRALIA ONLY
Note - A minimum of clearance of 1200mm is required from the
chargrill burner to the filter of the rangehood.
6 | English
Note- Refer below for
models with chargrill
1200 mm
762 mm
TO
TO BOTTOM OF
*
VENTILATION HOOD
W
OPENING WIDTH
A 216
mm
124
G
E
mm
FRONT VIEW
A
260 mm
413 mm
464 mm
464 mm
Preparation
Before moving the range, protect any finished flooring and
secure the oven door(s) closed to prevent damage.
OVEN DOOR REMOVAL
To lighten the load or to fit through a doorway, the oven
door(s) can be removed. Remove only if necessary. Do not
remove the griddle/teppanyaki or any other component.
Door removal should be done only by a certified installer
or service technician. Do not lift or carry the oven door by
the door handle.
To remove, open the door completely. Rotate both hinge
locks forward to the open position, remove the screw
closest to the hinge on both sides of the door, and pull the
door forward. Refer to the illustration below.
To reinstall, slide the door onto the hinges. Rotate the
hinge locks back completely and install the screws.
SCREW
HINGE
LOCK
Oven door removal
Placement
The range has rear casters, which allow for easy move-
ment by lifting the front of the unit. Do not lift or carry the
range by the oven door handle.
Use an appliance dolly to move the range near the open-
ing. Place the appliance dolly on the side or back to pre-
vent damage. Remove and recycle packing materials. Do
not discard the anti-tip bracket supplied with the range.
If a riser has been specified, refer to the installation instruc-
tions packaged with the riser. The riser must be installed
before the range is installed.