After Use; Self Clean - Russell Hobbs 14845 Instructions

Turn the temperature control to max opposite the notch.
•
Wait until the thermostat light goes out.
•
Hold the iron close to (but not touching) the fabric.
•
Press the
•
You may have to press it 2 or 3 times to pump water through the system.
•
Leave 4 seconds between shots, to let the temperature build up.
•

AFTER USE:

Unplug the iron.
•
Lift the bottom of the water inlet cover to open it.
•
Hold the iron over a sink, turn it upside down, and drain
•
the water from the reservoir.
Caution: The water may be hot
Place the iron on its heel.
•
Leave it to cool down completely.
•
When it's cold, wipe off any moisture, and close the water inlet cover.
•
Store the iron on its heel, to avoid corrosion and damage to the soleplate.
•

SELF CLEAN:

To prevent scale building up, use the self clean function regularly, at least
•
monthly in normal water areas, more often in hard water areas.
You'll need a basin or a large bowl to catch the water
•
coming out of the soleplate.
Fill the reservoir to the max mark.
•
Turn the temperature control to max, move the steam
•
control to
Place the iron on its heel.
•
Put the plug into the power socket, and wait till the
•
thermostat light goes out.
Now hold the iron over the basin or bowl, with the soleplate down (#9).
•
Move the steam control to
•
over the basin or bowl.
button (you're using the "shot of steam" function vertically).
.
, hold it there, and gently move the iron to and fro,
8