Maintenance; Sunshield Removal; Opening And Closing The Camera - Stahl IC-930-AFZ Serie Manuel D'instructions

12 Maintenance

Before doing any technical work on the
device, disconnect the power supply.
CAUTION! Device installation and
maintaining must be performed by
specialist technical staff only.

12.1 Sunshield removal

The product is supplied with the sunshield already
installed.
For installation or maintenance needs, the sunshield
can be dismantled. Unscrew the sunshield screws and
remove it.
Re-assemble the sunshield before fastening the
camera to the camera support.
Pay attention to the fixing. Tightening
torque: 4Nm (±0.5Nm).
Fig. 34
22
12.2 Opening and closing the
camera
To carry out some maintenance operations, the
camera must be opened.
Carefully remove the front slide. Pay
attention not to damage the internal
connection cables.
Unscrew the closure screws and remove the slide
connected to the front of the camera.
Fig. 35
To close the camera, follow the inverse procedure.
Pay attention to the fixing. Tightening
torque: 4.5Nm (±0.5Nm).
MNTCNVX_1915_EN