Instructions For Normal Operation; Maintenance; Routine Maintenance (To Be Performed On A Periodic Basis); Inspecting The Cables - Stahl EC-94 Série Manuel D'instructions

10 Instructions for normal
operation
Before carrying out any type of
intervention, read the "Safety rules"
chapter carefully in the product manual.
Do not use the wiper if the ambient
temperature is under 0°C or if there is ice.
If it is left on, the wiper automatically
disables itself.
The device control can be performed through
different modes.
• Through the user's controls of the web interface (
9.2 Web interface, page 105).
• Through Video Management Software (VMS)
that supports the ONVIF protocol. In this case
the special controls are implemented using the
auxiliary commands of the ONVIF protocol.
24

11 Maintenance

Before carrying out any type of
intervention, read the Safety rules chapter
carefully in the product manual.
When contacting STAHL for assistance please provide
the serial number and the identification code of the
model.
Use only STAHL original spare parts.
11.1 Routine maintenance (to be
performed on a periodic basis)

11.1.1 Inspecting the cables

The cables should not show signs of damage or wear,
which could generate hazardous situations. In this
case extraordinary maintenance is necessary.

11.1.2 Replacing the gasket

Replace the connection compartment cover seal
using the one supplied.
Open and close the connection compartment as
described in the previous chapters.
Replace the gasket, paying attention to position it
correctly.
Fig. 23
MNTCMPXHDC_2038_EN