Camera Board Description; Fuse Replacement - Stahl IC-930-AFZ Serie Manuel D'instructions

12.3 Camera board description

BOARD DESCRIPTION
Connector/ Function
Terminal
F1 Fuse
SW1 Reset dip-switch
Tab. 5
F1
Fig. 36
MNTCNVX_1915_EN

12.4 Fuse replacement

CAUTION! For continued protection against
risk of fire, replace only with same type and
rating of fuse. Fuses must be replaced only
by service personnel.
If necessary, the connector board's fuse can be
replaced. The new fuse must comply with the
directions given in the table.
FUSES REPLACEMENT
Voltage
24Vac, 50/60Hz
24Vdc
Tab. 6
As an alternative, use approved fuses featuring the
same characteristics.
To replace the fuse, open the camera. (12.2 Opening
and closing the camera, page 22).
Identify the fuse to replace.
SW1
Fig. 37
Fuse F1
T 2A H 250V 5x20
F1 F1
23