Factory Default; Factory Default (Version With Wiper); Factory Default (Version Without Wiper); Cleaning - Stahl IC-930-AFZ Serie Manuel D'instructions

12.5 Factory Default

Once the factory default procedure has
terminated, you need to configure the unit
as described in the relevant chapter (10.1
Default IP address, page 20).
12.5.1 Factory Default (version with
wiper)
• Disconnect the power supply to the unit.
• Short circuit terminals 4 and 5 of CONN 2 (or the
relevant conductors, Tab. 2, page 16).
• Power the unit. Wait for 2 minutes.
• Disconnect the power supply to the unit.
• Remove the short circuit.
• Power the unit.
12.5.2 Factory Default (version without
wiper)
It is possible to reset to the factory default settings.
Follow the procedure below:
• Disconnect the power supply to the unit.
• Open the camera (12.2 Opening and closing the
camera, page 22).
• Identify the reset dip switch (SW1,12.3 Camera
board description, page 23).
• Set the reset dip switch to ON.
• Power the unit. Wait for 2 minutes.
• Disconnect the power supply to the unit.
• Set the reset dip switch to OFF.
• Re-insert the slide and close the camera. Be
especially careful not to damage internal cables
during closure.
• Power the unit.
24

13 Cleaning

Frequency will depend on the type of
environment in which the product is used.

13.1 Cleaning the window

Avoid ethyl alcohol, solvents, hydrogenated
hydrocarbide, strong acid and alkali. Such
products may irreparably damage the
surface.
We recommend using a soft cloth with neutral soap
diluted with water or specific products to clean the
glasses lenses.
14 Information on disposal
and recycling
The European Directive 2012/19/EU on Waste
Electrical and Electronic Equipment (WEEE) mandates
that these devices should not be disposed of in the
normal flow of municipal solid waste, but they should
be collected separately in order to optimize the
recovery stream and recycling of the materials that
they contain and to reduce the impact on human
health and the environment due to the presence of
potentially hazardous substances.
The symbol of the crossed out bin is marked
on all products to remember this.
The waste may be delivered to appropriate collection
centers, or may be delivered free of charge to the
distributor where you purchased the equipment at
the time of purchase of a new equivalent or without
obligation to a new purchase for equipment with size
smaller than 25cm (9.8in).
For more information on proper disposal of these
devices, you can contact the responsible public
service.
MNTCNVX_1915_EN